AC position control system using PID

48,500.00 Exc Tax

AC position control system using PID

Out of stock




The AC Servo Motor / AC Position Control System Trainer kit is designed to demonstrate the position control with AC servomotor. The AC servomotor is used to adjust output / feedback potentiometer position. When the input / control potentiometer position is changed, the same change is followed by feedback pot. AC servo position control system controller & AC servomotor achieve this control action.


  • One 230/12V AC Servo Motor with gear, fixed on a mechanical frame with position dial indication
  • One position Servo pot is fixed with motor gear side for position sensing
  • Two nos. Line synchronized firing circuits for TRIAC
  • One Op-Amp PI Controller for control circuit
  • One 16/4 LCD display to indicate the set position and actual position in degree (0-355ΒΊ)
  • One potentiometer is provided to vary the motor position up to 355ΒΊ
  • +15V DC, 9V AC for control circuit, 230/12V AC for Power Circuit
  • One 4 Mfd/230V AC Capacitor is provided for Motor


  • Dspic 4011 Micro Controller Based PID Control System
  • Operating Voltage 5v & Operating Frequency 20MHZ

Mechanical Setup

  • One 12V two phase ac servo motor with Gear provided
  • Motor speed 1500rpm
  • One Servo potentiometer provided at the low speed shaft for position setting.
  • To study the Operation of AC servomotor position control with PI controller.

Technical Specification

  • Kit Working voltage : (220-240)VAC
  • Input Voltage :  24V AC
  • Input Frequency : 50Hz
  • Output Voltage 0 TO 24V AC
  • Output Current :  0.5 Amps

Bundle Contents

  • Ac position control system
  • Patch cards
  • 6A power supply card
  • 1A Fuse
  • Manual

Additional information

Weight 10.000000 kg


There are no reviews yet.

Be the first to review “AC position control system using PID”

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.