Interface Switch and Led with Cortex m4

This blog post explains how to interface switch and led with lpc4088 cortex m4 .

Steps to Blink led using switch with cortex m4 development board

1. Power: In the PCONP register, set the PCGPIO bit
2. Configure pins P4.0 to P4.15 as GPIO pins i.e. IOCON_P4_0 to IOCON_P4_15.
3. Select LED pins P4.0 to P4.7 as output and SWITCH pins P4.8 to P4.15 as input
4. Read the Switch status and Display its value in LED

C Source code to interface switch and led with cortex m4

#include "LPC407x_8x_177x_8x.h"

void delay_ms(long ms);
 
int main(void)
{
  //1. Set the PCGPIO bit
  LPC_SC->PCONP |= (1<<15);
 
  //2. Configure pins P4.0 to P4.15 as GPIO pins
  LPC_IOCON->P4_0 = 0;
  LPC_IOCON->P4_1 = 0;
  LPC_IOCON->P4_2 = 0;
  LPC_IOCON->P4_3 = 0;
  LPC_IOCON->P4_4 = 0;
  LPC_IOCON->P4_5 = 0;
  LPC_IOCON->P4_6 = 0;
  LPC_IOCON->P4_7 = 0;
  LPC_IOCON->P4_8 = 0;
  LPC_IOCON->P4_9 = 0;
  LPC_IOCON->P4_10 = 0;
  LPC_IOCON->P4_11 = 0;
  LPC_IOCON->P4_12 = 0;
  LPC_IOCON->P4_13 = 0;
  LPC_IOCON->P4_14 = 0;
  LPC_IOCON->P4_15 = 0;
 
  //3. Configure the pins P4.0 to P4.7 as output
  //   SWITCH pins P4.8 to P4.15 as input
  LPC_GPIO4->DIR= 0x00FF;
 
  while(1)
  {
   //4. Read the Switch Status and display it in LEDs
   LPC_GPIO4->PIN >>= 8;
   delay_ms(50);
  }
}

void delay_ms(long ms)      // delay 1 ms per count @ CCLK 120 MHz
{
  long i,j;
  for (i = 0; i < ms; i++ )
  for (j = 0; j < 26659; j++ );
}