I was doing ADC interface.but while executing the program i got an error.please help me to clear the error.The error is as follows.
C28xx: Power Failure on Target CPU: Error 0xA0000020/-1041 Error during: Execution, Device driver: Problem with the Emulation Controller. It is recommended to RESET EMULATOR. This will disconnect each target from the emulator. The targets should then be power cycled or hard reset followed by an emureset and reconnect to each target.
C28xx: Failed to remove the debug state from the target before disconnecting. There may still be breakpoint op-codes embedded in program memory. It is recommended that you reset the emulator before you connect and reload your program before you continue debugging