Power Electronics and Drives:Switched Reluctance Motor Control using DSPIC

Products>>Power Electronics and Drives>>Switched Reluctance Motor Control using DSPIC

Switched Reluctance Motor Control using DSPIC

switched-reluctance-motor-control-using-dspic PS-PED-SRM

Overall rating
2 Rating(s)

Learning Center

This setup consists
  • dsPIC30F4011 based controller
  • SRM Power module.
  • 1 HP SR Motor with Eddy current load.
  • Micro Chip dsPIC30F4011 16 Bit signal controller operating @ 20 MIPS.
  • 48KB Flash memory
  • 1 KB data EEPROM
  • 24 KB RAM for data memory
  • 16 bit timer counter
  • 6 Motor control/PWM with programmable dead band terminated at 20 pin FRC Connector
  • 2 capture inputs terminated at 20 pin FRC connector.
  • 6 Canal 10 Bit 0-5V ADC buffered and terminated at 20 pin FRC connector.
  • 20X4 Alphanumeric LCD Display
  • 4 switches provided for user input.
  • Reset switches provided for hardware reset
  • 1 UART is terminated at 9 pin connector
  • 4no’s of latest IGBT power module with heat sink and snubber circuit forms split DC link power circuit for SR Motor control.
  • 1 no. single phase diode bridge rectifier with capacitor provided for input AC to DC conversion for power circuit
  • High speed opto provided for all IGBT PWM isolation.
  • High speed opto provided for all IGBT PWM isolation.
  • 2 no. of split capacitor provided for SRM power circuit.
  • 1 no. DC analog Voltmeter provided for voltage measurement.
  • 1 no. over current trip circuit with indicator and reset switch provided for protection.
  • 4 no’s of Hall Effect Current sensor with signal conditioning circuit provided for output and DC input current measurement.
  • 2 no’s of LED provided in front panel for SR position status indication.
  • Test points provided in the front panel for PWM and current waveform measurement.
  • 1 no of illuminated rocker switch provided for Power ON/OFF with fuse protection.
  • All are mounted in stylish metal cabinet with sticker front panel.
  • 1 no. of IGBT based single quadrant chopper power circuit provided for DC voltage to Eddy Dynamo meter for SR Motor loading purpose.
Bundle Contents
  • DSPIC30F4011 Evaluation Board
  • Motor with loading arrangements
  • RS232 Cable
  • Power Adaptor & Power card
  • Patch cards
  • CD: Manual, MPLAB IDE, Example Codes


  • Switched-Reluctance-Motor-Control-using-DSPIC.pdf

Enquiry Form

Send your enquiry to enquiry@pantechsolutions.net or call 7200083083 for Quick response

Join the World's Largest Technical Community

we respect your privacy.

Demos On YouTube