I Purchased Zynq FPGA board from Pantech Prolab. I am able to Program Zynq FPGA through Impact tool but can't Program it with System generator hardware co-simulation tool.
Steps I followed.
create QPSK modulation in matlab with xilinx blockset and through system generator hardware cosimulation option i created qpsk block set and try to programm it to zynq board. it display following error.
Could not find a ARM device on the board. Please check if the target is in:
1. Split JTAG mode - No operations are possible with ARM DAP
2. Non Jtag bootmode - Bootrom may need time to enable DAP. Please try again
Error occurred during "Simulation Initialization".