This JTAG programmer is the low cost version for programming xilinx devices using USB cable.It needs an additional software to download the program into FPGA.
High Speed J-Link JLink V8 USB ARM JTAG Emulator Debugger J-Link V8 Emulator Description SEGGER J-Links are the most widely used line of debug probes available today. It features unparalleled
Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer.
The USB ASP AVR Programming Device for ATMEL processors is a USB in-circuit programmer for Atmel AVR controllers. USBASP AVR PROGRAMMING DEVICE FOR ATMEL PROCESSORS simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver; no special USB controller is needed.
The USB Blaster Download Cable interfaces a USB port on a host computer to an Altera® FPGA mounted on a printed circuit board. The cable sends configuration data from the PC to a standard 10-pin header connected to the FPGA. You can use the USB Blaster cable to iteratively download configuration data to a system during prototyping or to program…
This USB to UART/ESP8266 Adapter Programmer for ESP-01 WiFi Modules with CH340G Chip converts the signal from a USB interface to a PC / laptop to match a serial module ESP8266.