Power Theft Detection and Billing Using Arduino
₹8,000.00 Exc Tax
This paper consists of power theft detection and automatic bill management system. So we created a great solution to that power theft and automatic bill management using Arduino microcontroller. In this, we used a current sensor and voltage sensor to find the power theft and automatic billing system. If consumer connected overload means the bill amount was calculated but the lamp should not on. They want to call the electricity person compulsory than only they operate the load.
Shipping: 4 to 8 working days from the date of purchase
Package Includes:
-
Complete Hardware Kit
-
Demo Video-Embedded Below
-
Abstract
-
Reference Paper
-
PPT (20 Slides)
-
!!! Online Support !!!
100 in stock
Description
Abstract
In this project, we developed power theft detection and billing using Arduino Uno. Electrical based power theft in this we using Arduino Uno microcontroller and relay board two lamps and most important thing current sensor and voltage sensor but voltage is constant so we gave directly 230v. when the consumer added additionally load means the power theft was detected by this method and how much power will be consumed we are calculated and created a bill for that consumed power.
Introduction
In normal human life, electrical power is the most important thing. But human is wasting the electrical power and some bade doing theft also in the transmission line of TNEB. So that we created a great solution to that power theft and automatic bill management using Arduino microcontroller. In this, we used a current sensor and voltage sensor to find the power theft and automatic billing system.
Proposed system
This paper consists of power theft detection and automatic bill management system. So we created a great solution to that power theft and automatic bill management using Arduino microcontroller. In this, we used a current sensor and voltage sensor to find the power theft and automatic billing system. If consumer connected overload means the bill amount was calculated but the lamp should not on. They want to call the electricity person compulsory than only they operate the load.
Block Diagram
Demo Video
Hardware Tools
- Arduino Uno
- Relay Board
- Lamp 1
- Lamp 2
- Current Sensor
- RTC module
Software Tools
- Arduino IDE
- Embedded-C
Additional information
Weight | 1.000000 kg |
---|
Reviews
There are no reviews yet.