BLDC Motor Control Using DSPIC

Call for Price

This product describes a fully working and highly flexible software application for using the dsPIC30F to control brushless DC (BLDC) motors.The program is written in C and has been specifically optimized and well annotated for ease of understanding and program modification.

SKU: PED002 Category:

Description

This setup consists

  • dsPIC30F4011 based controller
  • 3 Phase IGBT based power module.
  • 1 HP BLDC Motor with spring balance load

Controller : dSPIC30F4011

  • Micro Chip dsPIC30F4011 16 Bit signal controller operating @ 20 MIPS.
  • 48KB Flash memory
  • 1 KB data EEPROM
  • 24 KB RAM for data memory
  • 16 bit timer counter
  • 6 Motor control/PWM with programmable dead band terminated at 20 pin FRC Connector
  • 3 capture inputs are terminated 20 pin FRC connector.
  • 6 Canal 10 Bit 0-5V ADC buffered and terminated at 20 pin FRC connector.
  • 20X4 Alphanumeric LCD Display
  • 4 switches provided for user input.
  • Reset switches provided for hardware reset
  • 1 UART is terminated at 9 pin connector

3 Phase Intelligent Power Module

  • 6 No’s high speed opto isolator provided for PWM isolation.
  • 1 no of IGBT-IPM PM25CL1A120 with suitable snubber circuit and heat sink provided for power circuit.
  • Rating of device is 600V @ 20 Amps.
  • Isolated + 15V @1Amps provided for control IC.
  • 1 no of Single phase Diode rectifier (600V, 25 Amps) with filter capacitor provided for input AC rectification for power circuit input with fuse protection.
  • 1 no of analog DC Voltmeter provided for Voltage measurement.
  • 4 No of Hall Effect Current Sensor provided for output current and DC current measurement
  • 1 No of LED provided to indicate Trip status.
  • Over load trip circuit provided for overload protection. & short circuit protection
  • 1 no. of reset switch provided to reset the TRIP function.
  • 15 No’s of test point provided in control system for reform measurement in CRO
  • All are mounted in attractive powder coated cabinet with sticker front panel with mimic diagram indication.
  • 230V AC input, one number of power ON/OFF Switch with indication.

1 HP BLDC Motor Spring Balanced Load with Hall Sensor

  • Rated Power : 1 HP
  • Phase : 3 Phase
  • Rated Voltage : 48 V
  • Rated Speed : 3000 rpm
  • Rotor Pole : 4 Poles
  • Position Sensor : 3 no’s of Hall Sensor mounted with 120 Electrical degree

Bundle Contents

  • DSPIC30F4011 Development Board
  • 1HP BLDC Motor with loading arrangements
  • Power Module
  • RS232 Cable
  • Power Adaptor
  • Patch cards

Additional information

Weight 50.000000 kg

Reviews

There are no reviews yet.

Be the first to review “BLDC Motor Control Using DSPIC”

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.