Description

Abstract

In this paper consist of vehicle safety using Arduino Uno. The vehicle we installed sensors and GPS module. Gas sensor, seat belt, mems sensor, an ultrasonic sensor buzzer circuit also added in this project. The gas sensor is using to find the alcohol level in the driver of the vehicle and seat belt sensor is using to find the seatbelt is wear or not. If both are sensor value is not normal means the vehicle doesn’t start. Mems sensor is found in the position of the vehicle if the sensor value is abnormal means the GPS value is displayed in the localhost at the same time buzzer will blow. The ultrasonic sensor is found the distance of the front vehicle distances very near means the ultrasonic sensor will slow down the vehicle and buzzer will blow continually in the method and one thing we uploaded all values in localhost.

Proposed System

This paper consists of the safety purposes of the vehicle and here the sensor is used to monitor the vehicle. If any abnormal value means this system will activate the buzzer and sensor value is uploaded to the localhost. The driver was drunk means the vehicle doesn’t start the same as seatbelt function also in the method.

Block Diagram

Hardware Requirements

• Arduino Uno
• Nodemcu ESP8266
• GPS Module
• Ultrasonic Sensor
• Mems Sensor
• Seatbelt Sensor
• Gas Sensor
• Buzzer
• Robot Setup

Software Requirements

• Arduino IDE
• Embedded C
• Localhost