To Construct Single Phase Semi Controlled Rectifier with RL-Load using Matlab Code generation tool with controller TMS320F28027F.
1.Power converter circuit has to be designed and simulation is verified in Matlab as shown in figure below.
2.Simulation in Matlab
4.After completion of simulation verification, Firing pulse generation circuit has to be detached to generate code for LaunchPad TMS320F28027F.
5.Now follow the steps in CONFIGURATION SETTINGS TO INTERFACE TMS320F28027F WITH MATLAB.
6.As shown below, use the pulse generating section alone by replacing the input and output ports with GPIO blocks.
7.Code Generation for TMS320F28027F LaunchPad using Matlab
8.Verify all power to the Trainer Kit is in OFF status.
9.Place the LaunchPad TMS320F28027F on the board slot as shown in Fig 2.5.
10.Power up the LaunchPad using the USB cable connected with the PC/Laptop
11.Follow the steps in PROGRAMMING THE LAUNCHPAD TMS320F28027F USING CODE COMPOSER STUDIO.
12.After programming, LaunchPad is ready to Generate the Pulse. Press reset once.
13.Now connect the Isolation Transformer unit through 14pin cable to the board as Shown in Fig: 2.11.
14.Now verify the power switch on the board is in OFF Status and power ON the Isolation Transformer Unit. Compare the ZCD and the generated Pulse from LaunchPad using Oscilloscope.
15.Below Screenshot shows the Comparison of generated pulse with the ZCD.
16.Now verify the pulses across (G1, K1) and (G3, K3).
17.Below Screenshot shows the Pulses applied to SCR for Triggering
18.Now connect the Power Circuit as per the Circuit Diagram shown in (Fig: 7.8) or as per the Connection Diagram shown in (Fig: 7.9). Verify the connection.
19.Check the fuse F1 is proper with (230V/1A) rating.
20.Now switch ON the Main Power Switch on the Trainer Kit.
21.Analyse the Output waveforms and current waveforms for various firing angle by pressing the Key (S3) in LaunchPad TMS320F28027F and tabulate the results.
22.For waveforms in DSO
23.Hardware Output waveforms
TON = SCR ON time from Output voltage waveform using DSO in ms.
TOFF = SCR OFF time from Output voltage waveform using DSO in ms.
Alpha α = Calculated value using formula in degree.
Vo = Measured Output Voltage using Multimeter and Calculated Output voltage in Volts.
Vpk = Input AC voltage in Volts.
1.Total Time Period for Half Cycle
2. Output Voltage
Vpk= Input ac voltage in volt.
a= Firing angle in degree.
β = Extinetion angle.
Thus Single Phase Semi Controlled Rectifier with RL-Load using TMS320F28027F was done successfully, Output waveforms and Input waveforms for various firing angle was analyzed and verified
☞The below screenshot show ,How to configure an constant firing angle.
☞To Vary the firing angle by using keys (S3) in LaunchPad TMS320F28027F ,follow the steps shown below.
☞ Open the If Action Subsystem1.
Change the value by opening frequency3 to any value of incremental step for E.g. as 5 and Ok. Now by pressing the key once it increments by 5degree.