Forums Microcontroller Boards ARM Interfacing to arm 7 lpc2148

Interfacing to arm 7 lpc2148

Link to this post 07 Feb 15

Dear Sir/Madam,
I'm Varuna J H , and I'm doing a project in which components like Arm 7 Lpc2148 , LCD 20x4 , rfid,matrix keypad and thermal printer. I'm stuck with interfacing and confused where to connect to those components in arm.Also whether to use uart connection or not if so for which components to use uart.So need help in this. I hope you'll help me out in this.

Thank you

Varuna J H

Link to this post 08 Feb 15

let me know what kind of starter kit used for lpc2148,is it integrated circuit or a low cost evaluation board.

only if i know the kind of the board and project i could proceed

Link to this post 04 May 15


how to interface usb mass stroge to Lpc2148

Link to this post 17 Jun 15

i try to debug HEX file in LPC2138 using flash-magic (UART0 Communication using MAX232). but it shows following error
1) failed to auto-baud step 1
2)device signature is fail
can you guide for resolve above problem
& any hardware & software changes is required please tell me
thank you